Pci error while updating region
If you have a technical inquiry please search our community or browse our technical categories such as Programmable Devices or Embedded Solutions.A board to discuss topics on Kintex Ultra Scale, Virtex Ultra Scale, Kintex Ultra Scale , Virtex Ultra Scale and Zynq Ultra Scale MPSo C including device architecture, clocking, Select IO, signal integrity, packaging, power, and related topics.Therefore I am having trouble pinpointing the issues causing this.Previously my PC was on a Windows 8.1 version and the issue did not arise until after I upgraded to Windows 10.The fresh windows 10 install also was installed on a brand new hard disk drive so it could not have been a HDD issue, I only replaced it because Crystal Disk had caution on the old drive (it is fine on the new drive).My RAM also isn't an issue as I have ran Mem Test86 for approximately 5-6 hours and everything checked out fine.I have swapped several torrent clients and still am able to reproduce the same issue, a BSOD with "Page Fault in Non Paged Area." Downloading large files via web browser or Skype were tested with no issues, however the BSOD often pops up downloading any torrent on any client and the file can be any size.My Windows 10 Copy is genuine and I had recently done a fresh install in an attempt to eradicate any potential problems with no avail.
Benefit: Allows Intel ME FW to address some issues that otherwise would require a new silicon stepping.
Make sure you shutdown after you flash (reboot is not enough) Also, if it wasn't clear by the utility this flash was done inside of Windows, although I'm sure it would work the same if performed from a DOS boot.
12672 Intel(R) MEInfo Version: 220.127.116.116 Copyright(C) 2005 - 2012, Intel Corporation. Intel(R) ME code versions: BIOS Version: 3010 MEBx Version: Not available Gbe Version: 1.3 Vendor ID: 8086 PCH Version: 5 FW Version: 18.104.22.1686 UNS Version: Not Available LMS Version: Not Available MEI Driver Version: 22.214.171.1245 Wireless Hardware Version: Not Available Wireless Driver Version: Not Available FW Capabilities: 0x00101460 Intel(R) Anti-Theft Technology - PRESENT/ENABLED Intel(R) Capability Licensing Service - PRESENT/ENABLED Protect Audio Video Path - PRESENT/ENABLED Intel(R) Dynamic Application Loader - PRESENT/ENABLED Cryptography Support: Disabled Last ME reset reason: Power up Local FWUpdate: Enabled BIOS Config Lock: Disabled Gb E Config Lock: Disabled Host Read Access to ME: Enabled Host Write Access to ME: Enabled SPI Flash ID #1: EF4017 SPI Flash ID VSCC #1: 20052005 SPI Flash BIOS VSCC: 20052005 BIOS boot State: Post Boot OEM Id: 00000000-0000-0000-0000-000000000000 Capability Licensing Service: Enabled OEM Tag: 0x00000000 Localized Language: Unknown Independent Firmware Recovery: Disabled Simple flash instructions (Inside Windows x64 using Intel Flash Programming Tool (NOT FWUPDATE! FOR TINKERERS ONLY - Don't bother with this information unless you are testing things out. Just tested and you can also update to the latest GBE firmware included in that ME update and it works perfectly fine.
Discuss AXI Infrastructure specifc topics including AXI Smart Connect, AXI Interconnect, AXI-Stream, bridges, DMA cores, PS-PL AXI Interfaces, Custom AXI Peripherals, BFM and AXI Verification IP (VIP).
Discuss board bring-up, boot and configuration topics for Zynq-7000, Zynq Ultra Scale MPSo C and Micro Blaze based FPGA designs.
Topics include secure and non-secure boot flow including programming the boot device (QSPI, JTAG, SD e MMC, NAND, NOR), bootrom, FSBL, loading of the bitstream, fallback/multi-boot, programming of e FUSEs and BBRAM.